Husqvarna V548 Owner Manual - Page 24
Lubrication, general information, Lubrication schedule, Refer, Interval, Month, Yearly, hours
![]() |
View all Husqvarna V548 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Lubrication, general information • Remove the ignition key to prevent accidental movements during lubrication. • Clean the area before you lubricate a part on the product. • Use engine oil when you lubricate with an oil can. • When you lubricate with grease, use a chassis or ball bearing grease that prevents corrosion. Remove unwanted grease after lubrication. • Lubricate 2 times a week if you operate the product daily. • Do not spill lubricant on the drive belts or the grooves of the belt pulleys. If you do spill, clean with alcohol. If the friction between the drive belt and the pulley is not sufficient after you clean with alcohol, replace the drive belt. CAUTION: Do not use gasoline or other petroleum products to clean drive belts. Lubrication schedule A B B C C D AD E F Refer Lubrication to A Lubricate the grease nipple on the pivot axle with a grease gun. B Lubricate the grease nipple on the wheel axle with a grease gun. Replace the filter. C Replace the hydraulic oil.10 Do a check of the hydraulic oil level. D Lubricate the grease nipple with a grease gun. Replace the engine oil.11 E Do a check of the engine oil level. Interval Month ly Yearly Each 50 hours Each 250 hours Each 500 hours X X X X X X X X X X X X X X X X X X 10 For Parker HT-1000, replace each 750 h. For other qualified hydraulic oils, first change 750 h, then each 500 h. For other hydraulic oils not listed, first change 750 h, then each 250 h. 11 Replace engine oil each 50 hours when operating with a heavy load or at high ambient temperatures. 24 1994 - 002 - 05.12.2022
![](/manual_guide/products/husqvarna-v548-owner-manual-1153757/24.png)