IBM 6400-I15 Operation Guide - Page 96
Fault Correction Procedure
![]() |
View all IBM 6400-I15 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
status and fault messages Fault Correction Procedure 1 Press any key on the operator panel, except Stop, to silence the alarm if necessary. Pressing the Form Feed key will silence the alarm and cause the paper to move. The top-of-form setting will be lost. 2 Write down the number of the displayed error message. 3 Use the fault explanation to fix the problem, if possible. 4 Press Stop to clear the fault message. Press Start to return to READY state, and resume printing. 5 If the fault message reappears, power off the printer, wait 15 seconds, then power on the printer. 6 Run your print job again. If the fault message reappears, turn off power to the printer, then call an IBM service representative. Otherwise, no further attention is required. The following pages list each printer status message and fault message. For fault messages, suggestions are offered for correcting the fault condition. 82 Operator's Guide
![](/manual_guide/products/ibm-6400-operation-guide-897a23c/96.png)