IBM 6500-V05 Maintenance Manual - Page 249

Loading Through the Network Interface Card (NIC) ATTENTION 7. At the C:\download> prompt type: filename.exe (Where filename is the six-digit microcode P/N) This will expand the file and create the .prg file needed in the next step. 8. Note the filename, which is a six digit number plus .prg. This .prg file is the file you will download into the NIC. 9. Start the FTP (file transfer protocol) program by typing: ftp nnn.nnn.nnn.nnn (where nnn.nnn.nnn.nnn represents the IP Address of the printer.) 10. Log in to the printer by typing: root You are given a password prompt. NOTE: The default is no password. If the program requires a password, contact the system administrator. 11. At the password prompt, press . 12. Once logged in, type the following sequence at the command prompt to download the filename.prg file to the printer: cd dest cd d1prn bin put filename.prg (where filename.prg is the file name you noted in step 8) Do not interrupt the downloading process once it has started. Interrupting a download will damage the flash memory on the controller board and NIC. 13. When the download is complete, exit the FTP program by typing: quit 14. When the new software has successfully loaded into flash memory and the printer has reset itself, set the printer power switch to O (off). 15. Unplug the AC power cord from the printer. 16. If required, reconnect the data input cable(s) to the printer. 17. Plug the AC power cord into the printer. 18. Set the printer power switch to | (on). 249