IBM 6500-V05 Maintenance Manual - Page 477

ATTENTION The power stacker assembly mounts to the rear upper frame cross-member and the cabinet floor. It is a snug fit. During installation, grasp the stacker by the vertical rails and take care to avoid scratching painted surfaces or damaging the stacker. NOTE: It may be easier to wear gloves for the next step. 14. Position the stacker assembly slightly to the right in order to clear the air exhaust duct, insert the vertical rails inside and under the upper frame cross-member, then slowly swing the base of the stacker assembly into the cabinet. (Refer to Figure 77a.) Leave the stacker loose in the rear of the cabinet. 15. Gather the stacker rail cable, elevator I/O cable, logic cable, and power cable. Route the cables outboard of the elevator assembly. (Figure 74.) Elevator Assembly Rail Cable Elevator I/O Cable Stacker Logic Cable (To operator panel) (To Card Cage) Stacker Power Cable Figure 74. This figure shows how to route the stacker cables from the elevator and frame rail to the card cage. 477