IBM 6500-V05 Maintenance Manual - Page 340

Memory Modules and Security Key Code Loads TN ANSI CT Code V / IGP IPDS X X X X * This is also the Base ASCII-only security key Part Number 39U2464 39U2467 39U2468 Installation 1. Put on a static wrist strap and ground the lead to an unpainted part of the printer frame. Touch the printer frame with the hand wearing the wrist strap before you touch memory modules or the controller board. 2. Position the security key on controller board connector J9 so that the lock indentation is on the same side as the locking tab on connector J9. Gently press the security key down onto the pins until the locking tab engages the lock indentation and locks the key in place. (See Figure 18.) NOTE: Installing flash memory from one controller board to another does not transfer all operating system software, so you must download the emulation again. 3. Insert the flash SIMM into socket J11 on the controller board at about a 45 degree angle. Position the flash SIMM with the notched end toward the right side of the controller board. Press the SIMM gently into the socket until the edge connectors are seated, then press the SIMM downward until the side latches lock the SIMM is place. (See Figure 18, page 341.) 4. Cabinet Model: Install the paper guide assembly (page 348). Pedestal Model: Install the top cover assembly (page 327). 5. Download the emulation (page 231). 6. Return the printer to normal operation (page 314). 7. Using the configuration printout(s) you made in step 1 of the removal procedure, reset and save the printer configuration(s). (Refer to the Setup Guide.) 340