Home » IBM Manuals » Desktops » IBM 8307 » Manual Viewer

IBM 8307 Hardware Maintenance Manual - Page 59

Drive, specifications, Notes, Installing, drive

UPC - 087944816577

Add to My Manuals
Save this manual to your list of manuals

Page 59 highlights

Types 8303, 8304, and 8312 This section provides information and instructions for installing and removing internal drives. Internal drives are devices that your computer uses to read and store data. You can add or replace drives to your computer to increase storage capacity and to enable your computer to read other types of media such as CD-ROM. Internal drives are installed in bays. In this book, the bays are referred to as bay 1, bay 2, and so on. When you install an internal drive, it is important to note what type and size of drive that you can install in each bay. Also, it is important to correctly connect the internal drive cables to the installed drive. Drive specifications: Your computer might come with the following IBM-installed drives: v A 3.5-inch diskette drive in bay 1 v A CD-ROM drive or DVD-ROM drive in bay 2 (some models) v A 3.5-inch hard disk drive in bay 3 Any bay that does not have a drive installed has a static shield and bay panel installed. The following illustration shows the locations of the drive bays. The following list describes some of the drives that you can install in each bay and their height requirements: 1 Bay 1 - Maximum height: 25.8 mm (1.0 in.) 2 Bay 2 - Maximum height: 43.0 mm (1.7 in.) 3 Bay 3 - Maximum height: 25.8 mm (1.0 in.) 3.5-inch diskette drive (preinstalled) CD-ROM drive or DVD-ROM drive (preinstalled in some models) 3.5-inch hard disk drive (preinstalled) Notes: 1. Drives that are greater than 43.0 mm (1.7 in.) high cannot be installed. 2. Install removable media (tape or CD) drives in the accessible bay (bay 2). Installing a drive: To install a CD-ROM drive or DVD-ROM drive in bay 2, follow these steps: 1. Remove the cover (see "Removing the cover" on page 40). 2. If the drive you are installing is a removable-media drive, remove the bay panel from the front bezel. Chapter 5. Installing Options 53

Section	Page
Contents	5
Chapter 1. About this manual	7
Important Safety Information	7
Chapter 2. General Checkout	9
Chapter 3. General information	11
Features	11
Types 8301 and 8302	11
Types 8303, 8304, and 8312	13
Types 8305, 8306, 8309, and 8313	15
Types 8307, 8308, 8310, 8311, 8314, and 8315	17
Physical specifications	19
Types 8301 and 8302	19
Types 8303, 8304 and 8312	20
Types 8305, 8306, 8309, and 8313	22
Types 8307, 8308, 8310, 8311, 8314, and 8315	23
Available options	24
Types 8301 and 8302	24
Types 8303, 8304 and 8312	25
Types 8305, 8306, 8309, and 8313	26
Types 8307, 8308, 8310, 8311, 8314, and 8315	27
Chapter 4. Diagnostics	29
Setup Utility program	30
Product Recovery Program menu	31
Diagnostics	32
Diagnostics program download	32
Navigating through the diagnostics programs	32
Running diagnostics tests	32
Test selection	32
Test results	33
Fixed disk advanced test (FDAT)	33
Quick and Full erase - hard drive	35
Viewing the test log	36
Chapter 5. Installing Options	37
Installing external options	37
Locating connectors on the front	37
Types 8301 and 8302	37
Types 8303, 8304, and 8312	37
Types 8305, 8306, 8309, and 8313	38
Types 8307, 8308, 8310, 8311, 8314, and 8315	38
Locating the connectors on the rear	39
Types 8301 and 8302	39
Types 8303, 8304, and 8312	41
Types 8305, 8306, 8309, and 8313	43
Types 8307, 8308, 8310, 8311, 8314, and 8315	43
Obtaining device drivers	45
Installing internal options	45
Removing the cover	46
Types 8303, 8304, and 8312	46
Types 8305, 8306, 8309, and 8313	46
Types 8307, 8308, 8310, 8311, 8314, and 8315	47
Locating components	48
Types 8303, 8304, and 8312	48
Types 8305, 8306, 8309, and 8313	49
Types 8307, 8308, 8310, 8311, 8314, and 8315	50
Identifying parts on the system board	50
Types 8303, 8304, and 8312	50
Types 8305, 8306, 8309, and 8313	51
Types 8307, 8308, 8310, 8311, 8314, and 8315	52
Installing memory	53
Installing adapters	54
Types 8303, 8304, and 8312	54
Installing adapters in Types 8305, 8306, 8309, and 8313	56
Installing adapters in Types 8307, 8308, 8310, 8311, 8314, and 8315	57
Installing internal drives	58
Types 8301 and 8302	58
Types 8303, 8304, and 8312	59
Installing internal drives in Types 8305, 8306, 8309, and 8313	62
Installing internal drives in Types 8307, 8308, 8310, 8311, 8314, and 8315	65
Installing a rope clip	70
Types 8303, 8304, and 8312	70
Installing a rope clip in Types 8305, 8306, 8309, and 8313	70
Installing a rope clip in Types 8307, 8308, 8310, 8311, 8314, and 8315	71
Changing the battery	73
Replacing the cover and connecting the cables	73
Types 8303, 8304, and 8312	73
Types 8305, 8306, 8309, and 8313	74
Types 8307, 8308, 8310, 8311, 8314, and 8315	74
Chapter 6. FRU Removals	77
Removing the cover Types 8301 and 8302	77
Removing the CD-ROM drive Types 8301 and 8302	77
Front bezel Types 8307, 8308, 8310, 8311, 8314, and 8315	78
Replacing a microprocessor	78
Hard disk drive removal	79
Types 8303, 8304, and 8312	79
Drive specifications	79
Installing a drive	79
Types 8305, 8306, 8309, and 8313	80
To connect an additional IDE hard disk drive	82
Types 8307, 8308, 8310, 8311, 8314, and 8315	83
Power supply removal	83
Types 8301 and 8302	83
Types 8303, 8304, and 8312	84
Types 8305, 8306, 8309, and 8313	85
Types 8307, 8308, 8310, 8311, 8314, and 8315	86
System board removal	86
Types 8301 and 8302	86
Types 8303, 8304, and 8312	87
Types 8305, 8306, 8309, and 8313	88
Types 8307, 8308, 8310, 8311, 8314, and 8315	89
Replacing the cover, Types 8301 and 8302	89
Chapter 7. Symptom-to-FRU Index	93
Hard disk drive boot error	93
Power Supply Errors	93
Diagnostic error codes	95
Beep symptoms	113
No-beep symptoms	115
POST error codes	116
Miscellaneous error messages	131
Undetermined problems	133
Chapter 8. Parts listing	135
Chapter 9. Additional Service Information	269
Security features	269
Passwords	269
Power-on password	269
Removing a power-on password	269
Administrator password	269
Administrator password control	270
Operating system password	270
Vital product data	270
Management Information Format (MIF)	270
Alert on LAN	271
BIOS levels	271
Flash update procedures	271
Flash from Operating System (WinPhlash)	272
Flash from CD-ROM ISO image	272
Flash recovery boot block jumper	273
Power management	275
Automatic configuration and power interface (ACPI) BIOS	275
Advanced Power Management	275
Automatic Hardware Power Management features	275
Setting Automatic Hardware Power Management features	275
Automatic Power-On features	276
Chapter 10. Related service information	277
Safety information	277
General safety	277
Electrical safety	278
Safety inspection guide	279
Handling electrostatic discharge-sensitive devices	280
Grounding requirements	281
Safety notices (multi-lingual translations)	281
Send us your comments!	310
Problem determination tips	311
Notices	311

Match case Limit results 1 per page

Types

8303,

8304,

and

8312

This

section

provides

information

and

instructions

for

installing

and

removing

internal

drives.

Internal

drives

are

devices

that

your

computer

uses

read

and

store

data.

You

can

add

replace

drives

your

computer

increase

storage

capacity

and

enable

your

computer

read

other

types

media

such

CD-ROM.

Internal

drives

are

installed

bays

this

book,

the

bays

are

referred

bay

and

on.

When

you

install

internal

drive,

important

note

what

type

and

size

drive

that

you

can

install

each

bay.

Also,

important

correctly

connect

the

internal

drive

cables

the

installed

drive.

Drive

specifications:

Your

computer

might

come

with

the

following

IBM-installed

drives:

3.5-inch

diskette

drive

bay

CD-ROM

drive

DVD-ROM

drive

bay

(some

models)

3.5-inch

hard

disk

drive

bay

Any

bay

that

does

not

have

drive

installed

has

static

shield

and

bay

panel

installed.

The

following

illustration

shows

the

locations

the

drive

bays.

The

following

list

describes

some

the

drives

that

you

can

install

each

bay

and

their

height

requirements:

±1²

Bay

Maximum

height:

25.8

(1.0

in.)

3.5-inch

diskette

drive

(preinstalled)

±2²

Bay

Maximum

height:

43.0

(1.7

in.)

CD-ROM

drive

DVD-ROM

drive

(preinstalled

some

models)

±3²

Bay

Maximum

height:

25.8

(1.0

in.)

3.5-inch

hard

disk

drive

(preinstalled)

Notes:

Drives

that

are

greater

than

43.0

(1.7

in.)

high

cannot

installed.

Install

removable

media

(tape

CD)

drives

the

accessible

bay

(bay

2).

Installing

drive:

install

CD-ROM

drive

DVD-ROM

drive

bay

these

steps:

Remove

the

cover

(see

“Removing

the

cover”

page

40).

the

drive

you

are

installing

removable-media

drive,

remove

the

bay

panel

from

the

front

bezel.

Chapter

Installing

Options