IBM 9228 User Guide - Page 52
Attention
![]() |
UPC - 000435947840
View all IBM 9228 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
- Slot 4, PCI-X, 64-bit, 133 MHz - Slot 5, PCI-X, 64-bit, 133 MHz - Slot 6, PCI, 32-bit, 33 MHz The computer starts the PCI devices in the following order, if you have not changed the default startup sequence: PCI Express x16 (slot 1), PCI Express x8 (slot 2), PCI Express x16 (slot 3), system-board IDE or Serial ATA (SATA) devices, PCI-X slots 4 and 5, and then PCI slot 6. v The computer comes with integrated IEEE 1394A (FireWire) support. v For a list of supported options for the computer, see http://www.ibm.com/ intellistation/; then, select your country and navigate to the list of options for the computer. To install an adapter, complete the following steps: 1. Read the safety information that begins on page v and "Installation guidelines" on page 29. 2. Turn off the computer and all attached devices (see "Turning off the computer" on page 18); then, disconnect all external cables and power cords. 3. Remove the side cover (see "Removing the side cover" on page 35). 4. Determine which PCI slot you will use for the adapter. Check the instructions that come with the adapter for any requirements, restrictions, or cabling instructions. It might be easier to route cables before you install the adapter. 5. If an adapter is already installed in the slot, remove it, using the following procedure, and place it on a static-protective surface: Note: For full-length adapters, rotate the rear adapter-retention bracket to the open (unlocked) position. Press the two blue release buttons located on the side of the front adapter-retention bracket that faces the adapters. If you are installing a smaller adapter, rotate only the rear adapter-retention bracket. Grasp the adapter and pull it out of the slot. If the slot is empty, remove the expansion-slot cover. From the rear of the computer, press on the slot cover. Grasp it and pull it out of the expansion slot. Store it in a safe place for future use. Attention: Expansion-slot covers must be installed in all empty slots. This maintains the electronic emissions standards of the computer and ensures proper ventilation of computer components. 6. Follow the instructions that come with the adapter to set jumpers or switches, if there are any. Attention: Avoid touching the components and gold-edge connectors on the adapter. 7. If you are installing a full-length adapter, remove the blue adapter guide (if any) from the end of the adapter. 40 IBM IntelliStation Z Pro Type 9228: User's Guide
![](/manual_guide/products/ibm-9228-user-guide-afd3cf8/52.png)