IBM 9513AG1 User Guide - Page 13

ENGLISH FRANÇAIS DEUTSCH ESPAÑOL Auto Setup for the PC Before carrying out this section, it is very important that The Setup Diskette for Windows 95 or Windows 98 has been run. (see page 6) Locate the operating system installed on your PC in the table below and follow the appropriate instructions. You may choose to run AUTO SETUP for each operating system that you use. This means that if you sometimes use your monitor while running any version of Windows and sometimes also use it from within DOS (not a DOS window), you must run AUTO SETUP for both Windows and DOS. You may run versions of AUTO SETUP in any order. If your PC does not run with the setup diskettes shipped with the monitor, refer to Manual Setup on page 13 The AUTO SETUP process only applies to the current screen mode. When a new mode is selected, repeat this section to reset the monitor Operating System Corresponding Auto Setup procedure DOS Windows 3.1 Windows 95 Windows 98 Window NT Operating System/2 (OS/2) Auto Setup for DOS on page 8 Auto Setup for Windows 3.1, Windows 95, Windows 98 or Windows NT on page 9 Auto Setup OS/2 on page 11 Before you begin AUTO SETUP for your PC: 1. Make a backup copy of the setup diskettes supplied with the monitor. 2. Make sure the PC's video mode is set in the range of the supported screen resolution shown in the table on page 19. You should perform AUTO SETUP for each screen mode you use. ITALIANO JAPANESE COMPL & WARR 7