IBM 9513AG1 User Guide - Page 17

ENGLISH FRANÇAIS DEUTSCH ESPAÑOL Auto Setup OS/2 If the monitor is in standby mode (STANDBY ON), it may automatically turn off while you are waiting for it to warm up. 1. Turn on the monitor first; then the PC. If the message CHECK SIGNAL CABLE is displayed, or if nothing is displayed check: • that the video interface cable is connected properly. • the correct video adapter card is installed. • the correct supported display mode is selected for your PC. 2. Wait approximately 15 minutes, until the monitor warms up. 3. Insert the diskette labelled 'IBM Monitor Installation Disk' into the diskette drive. 4. Select OS/2 SYSTEM, SYSTEMS SETUP, SYSTEM. Select SCREEN RESOLUTION 1024 X 768 X 256. 5. Select SCREEN REFRESH of 60HZ. 6. Close SYSTEMS and restart your system. 7. At the OS/2 command prompt, select the OS/2 FULL SCREEN command. 8. Press mouse button 2 and select SETTINGS or PROPERTIES (depending on your OS/2 version). 9. Select SESSION and then choose WIN-OS/2 FULL SCREEN. 10. Open the OS/2 full-screen window. 11. At the command prompt type A: and press ENTER. 12. Type TESTPATS and press ENTER. The size and diversity of the dot pattern varies with the screen resolution. 13. When the dot pattern appears, press the OSD Enter button the bottom of the monitor to display the initial OSD menu. along Position the mouse pointer at the bottom center of the screen. This allows AUTO SETUP to run properly. 14. Use an Arrow button ( or ) to select the IMAGE LOCK icon and press the OSD Enter button to access the function. 15. Using an Arrow button ( or ), select AUTOMATIC and press the OSD Enter button . This activates the AUTO SETUP procedure, which will optimize the display settings with the provided test pattern. The screen will dim, blink on and off several times, and you may notice small changes to the test pattern. To abort the AUTO SETUP function, press the ESCAPE key. ITALIANO JAPANESE COMPL & WARR 11