IBM 9513AG1 User Guide - Page 15

ENGLISH Auto Setup for Windows 3.1, Windows 95, Windows 98 or Windows NT FRANÇAIS DEUTSCH ESPAÑOL ITALIANO If the monitor is in standby 1. Turn on the monitor first; then the PC. mode (STANDBY ON), it may automatically turn off while If the message CHECK SIGNAL CABLE is displayed, or if nothing is you are waiting for it to warm up. displayed check: • that the video interface cable is connected properly. • the correct video adapter card is installed. • the correct supported display mode is selected for your PC. 2. Wait approximately 15 minutes, until the monitor warms up. 3. Drag the icon bar and tool bar, if they are displayed, to the bottom of the screen. 4. Insert the diskette labelled 'IBM Monitor Installation Disk' into the diskette drive. The size and diversity of the dot pattern varies with the screen resolution. 5. Check the operating system installed on your PC and follow the instructions from the table below. Operating System Windows 3.1 Windows NT 3.5 Windows 95 Windows 98 Windows NT 4.0 Step1 Open PROGRAM MANGER Select START Step2 Select FILE Step3 Select RUN Select RUN Step4 Type 'A:\TESTPAT' and press ENTER 6. When the test pattern appears, press the OSD Enter button bottom of the monitor to display the initial OSD menu. at the Position the mouse pointer 7. Use an Arrow button ( or ) to select the IMAGE LOCK icon at the bottom center of the screen. This allows AUTO and press the OSD Enter button to access the function. SETUP to run properly 8. Using an Arrow button ( or ), select AUTOMATIC and press the OSD Enter button . This activates the AUTO SETUP procedure, which will optimize the display settings with the provided test pattern. The screen will dim, blink on and off several times, and you may notice small changes to the test pattern. To abort the AUTO SETUP function, press the ESC key. 9. When finished, the OSD main menu returns. Press the Exit button once to exit from the OSD. JAPANESE COMPL & WARR 9