IBM x3655 User Guide - Page 60
illustration.
UPC - 883436014533
View all IBM x3655 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
Note: The terminator end of the cable does not go through the slot in the hard disk drive cage. 9. Connect the cables to the back of the tape drive. 10. Push the tape drive assembly into the bays, gently pulling the cables farther into the server as you do so, until the tape drive assembly stops. 11. Push the tray handle to the closed (locked) position. 12. Remove the backing from the hook-and-loop fastener on the SCSI terminator. Attach the terminator to the top of the CD/DVD drive bay as shown in the following illustration. SCSI terminator 13. Connect the tape drive signal cable connector and power cable connector to the system board (See "System-board internal cable connectors" on page 19 for the location of the connectors). 14. Route the SCSI signal cable under the SAS cable, through the slot in the side of the air baffle and connect it to the SCSI adapter. The following illustration shows the routing of the signal cable. Important: Make sure to route the cables so that you do not obstruct access to the fan connectors. 46 System x3655 Type 7985: User's Guide