IC Realtime ICIP-P2012T Product Manual - Page 11
Dial Switch Setup For Analog Speed Dome Only
View all IC Realtime ICIP-P2012T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
2.4 Dial Switch Setup (For Analog Speed Dome Only) The following operation is based on the ceiling mount speed dome. Here we are going to set speed dome address, baud rate and etc. There are two dial switches on the PTZ for you to set address, baud rate and etc. See Figure 2-2. Figure 2-2 2.4.1 Dial Switch Buttons Before you control speed dome, please set the speed dome address, baud rate, parity. Otherwise, you can not control the device! See Figure 2-3. Open speed dome transparent enclosure, you can view the dial switch buttons on the PTZ main board. You can follow the steps listed below to set the speed dome address, baud rate, and parity. Please note you need to restart the device to activate the new setup! For wall mount speed dome, you need to take out the packing material EPE, set the dial switch buttons and then put it back to the transparent enclosure module. 3