IC Realtime ICIP-P2012T Product Manual - Page 18
Wall Mount Bracket Installation
View all IC Realtime ICIP-P2012T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
4 WALL MOUNT BRACKET INSTALLATION 4.1 Component Installation The wall mount bracket and outdoor speed dome is shown as in Figure 4-1. Figure 4-1 4.2 Wall Mount Installation Steps 4.2.1 Installation Environments The wall mount speed dome can be installed in the hard construction wall in the indoor or outdoor environments. Before the installation, please make sure: z The wall is thick enough to install the expansion bolt. z The ceiling can at least sustain the 8x weight of the speed dome, bracket and the accessories. 4.2.2 Installation Steps 1) Dig a hole of 50mm diameter for cable exit in the installation wall. 2) In Figure 4-2, connect the adapter block to the internal thread of the wall mount bracket, until it reaches the end and then fix the set screw. Pull the intelligent speed dome composite cable through the adapter block and pull it out of the other end of the wall mount bracket. Line up the hook at the top of the external enclosure to the inside hole of the adapter block and then push it to the end, and then secure the three screws of the adapter block firmly. Please note this step is very important. Please make sure the screws are firm, otherwise, it may result in falling risk of the intelligent speed dome. 10