IC Realtime ICIP-P2012T Product Manual - Page 12
Baud Rate and Parity Setup
View all IC Realtime ICIP-P2012T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Figure 2-3 There are two dial switch buttons on the PTZ. You can use them to set speed dome address, baud rate, and parity respectively. It is 1 when you set the button as ON. For the protocol dial switch, you can refer to the following sheet. 1 is the lowest bit and the 8 is the highest bit. Please note the intelligent speed dome can automatically recognize the industrial standard protocol, PELCO-D. PELCO-P. Usually you do not need to set the protocol. 2.4.2 Baud Rate and Parity Setup For the dial switch button 1-4. 1 and 2 is to set baud rate. 3 and 4 is to set parity. Please refer to the following figure for detailed information. See Figure 2-4. Figure 2-4 Please refer to the baud rate sheet for detailed information. 1 2 Baud Rate OFF OFF 9600bps ON OFF 4800bps OFF ON 2400bps ON ON 1200bps Please refer to the parity setup sheet for detailed information. 3 4 Parity OFF OFF NONE ON OFF EVEN OFF ON ODD 4