Icom IC-F3161D Instruction Manual - Page 13

PANEL DESCRIPTION 2 MEMORY CH 1/2/3/4 KEYS "CH1" "CH2" "CH3" "CH4" Push to select the memory channels 1 to 4 directly. LONE WORKER KEY "LONE" 1 Push to turn the Lone Worker function ON or OFF. • If the Lone Worker function is activated, the Emergency function is 2 MONI KEY "MON" ➥ P ush to mute and release the CTCSS (DTCS) or 2-Tone automatically turned ON after the specified time period has passed with no operation is performed. 3 squelch mute. Open any squelch/deactivate any mute 4 while pushing and holding this key. (LMR operation only) ➥ Activates one of (or two of) the following functions on each HIGH/LOW KEY "H/L" Push to select the transmit output power temporarily or per- 5 channel independently: (PMR operation only) manently, depending on the pre-setting. 6 • Push and hold to un-mute the channel (audio is emitted; 'Audible' condition). • Ask your dealer for the output power level for each selection. 7 • Push to mute the channel (sets to 'Inaudible' only). • Push after the communication is finished to send a 'reset code'. TONE/RAN CH SELECT KEY "T SEL" ➥ While in analog mode operation, push to enter the continu- 8 (5-Tone/BIIS operation only) ous tone channel selection mode. Then select the desired 9 NOTE: The un-mute condition ('Audible' condition) may automatically return to the mute condition ('Inaudible' tone frequency/code setting with [CH Up] or [CH Down]. After the selection, push this key again to set. 10 condition) after a specified period. ➥ While in digital mode operation, push to enter the RAN 11 LIGHT KEY "LIGT" channel selection mode. Then select the desired RAN setting with [CH Up] or [CH Down]. After the selection, push 12 Push to turn the transceiver's backlight ON temporarily only this key again to set. 13 when the backlight function is turned OFF in the User Set mode. ➥ While in mixed (digital and analog) mode operation, push to enter the continuous tone channel selection mode. Then 14 select the desired tone frequency/code setting with [CH 15 LOCK KEY "LOCK" ➥ Push and hold for 1 sec. to electronically lock all program- Up] or [CH Down]. After the selection, push this key to set. After that, the RAN channel selection screen appears. Se- 16 mable keys for preventing accidental frequency changes lect the desired RAN setting with [CH Up] or [CH Down]. and unnecessary function access except the following: After the selection, push this key again to set. [PTT], [Call] (incl. Call A and Call B), [Moni(Audi)], [Light], [Emergency], [Surveillance], [Lone Worker] and [OPT 1/2/3]. ➥ Push and hold for 1 sec. again to turn the lock function OFF. 8