Icom IC-M200 Instruction Manual - Page 10

3 BASIC OPERATION ■■Setting a Call channel ■■Entering a channel name The Call channel is used to select Channel 9 (default). However, you can set another channel as the Call channel in each channel group. 1. Push [Ù] and [Ú] on the transceiver at the same time to select the desired channel group. (p. 5) 2. Hold down [16/C] for 1 second to select the Call channel of the selected channel group. ••"CALL" and Call channel number is displayed. 3. Hold down [16/C] again for 3 seconds (until a long beep changes to 2 short beeps) to enter the Call Channel Set mode. ••Channel number blinks. 4. Push [Ù] or [Ú] to select the desired channel. 5. Push [16/C] to set the displayed channel as the Call channel. ••2 short beeps sound. ••The channel number stops blinking and the setting is saved. L Push [CHAN] to cancel setting. You can enter a channel name of up to 10 characters each. A name with more than 6 characters is scrolled after you select a channel. L You cannot enter a channel name to 4 digit channels. L Capital letters, small letters (except f, j, k, p, s, v, x, z), 0 to 9, some symbols and space can be used. NOTE: Cancel Dualwatch, Tri-watch or Scan in advance. 1. Select the desired channel. 2. While holding down [CHAN], push [16/C] to edit the channel name. ••A cursor and the first character alternately blink. 3. Push [Ù] or [Ú] to select the desired character. L Push [16/C] or [CHAN] to move the cursor forward or backward. 4. Repeat step 3 to enter all characters. 5. Push [DW] to save the channel name. ••The cursor and the character stop blinking. L Push [SCAN] to cancel the editing. 7