Icom IC-M700PRO Instruction Manual - Page 18

6 CONNECTIONS AND INSTALLATION ■ Connections on the rear panel e Optional AT-130 q rt w u y R CAUTION: NEVER remove the i line fuse from the DC power cable. External speaker q ANTENNA CONNECTOR (p. 19) Connects a 50 ø HF band antenna with a 50 ø matched coaxial cable and a PL-259 plug. w GROUND TERMINAL  IMPORTANT! Connects to a ship's (or vehicle's) ground. See p. 18 for details. e ACC(1) and ACC(2) SOCKETS See p. 16 for details. r CLONE JACK For Dealer use only. t REMOTE SOCKET (p. 17) REMOTE socket for Marine and General versions. y EXTERNAL SPEAKER JACK Connects a 4 to 8 ø external speaker using a 1⁄4" monaural plug. This external audio is not muted by the [SPEAKER] switch on the front panel. 12 V battery u TUNER RECEPTACLE Connects a control cable to an optional AT-130 an- tenna tuner. A female connector is supplied for connection. i DC POWER RECEPTACLE Connects to a regulated 12-16 V DC power source such as a 12 V battery or DC power supply using the supplied DC power cable. CAUTION: DO NOT connect to a 24 V battery. This will damage the transceiver. ■ Unpacking Microphone (HM-180 1 Microphone hanger 1 DC power cable (OPC-1107A 1 Mounting bracket 1 Cushion rubber 4 Bracket knobs (8820000170 4 Flat washer (M5 4 NUTS AND BOLTS Allen bolt (M6 × 50 4 Self-tapping screws (M6 × 30 4 Nuts (M6; use 2 pcs. for each bolt 8 Flat washers (M6 8 Spring washers (M6 4 Self-tapping screws CONNECTORS (M3 × 16 for mic. hanger 2 DIN connector (8-pin for ACC1 1 DIN connector (7-pin for ACC2 1 Speaker plug (5610000440 1 Tuner connector (5610000150 1 FUSES DC power cable (30 A 1 1205 (internal 2 Pins for tuner connector (5610000160 4 Plates for tuner connector (6910009540 4 15