Icom IC-M700PRO Instruction Manual - Page 9
Selecting a frequency
View all Icom IC-M700PRO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
3 SELECTING A CHANNEL/FREQUENCY D Scan function The scan function allows you to automatically search for signals with a group of channels. There are 2 scan types (selectable in the set mode) as follows: Channel scan ch 2 ch 1 ch 50 ch 3 ch 5 scan is ch 4 cancelled when transmitting Scan operation q Rotate the [GROUP] selector to select the group you wish to scan. w If necessary, push [SQL] to close the squelch. • "SQL" appears. e Push [SCAN] to start scanning. • "SCAN" appears. r Push [SCAN] again to stop scanning. • "SCAN" disappears. Channel resume scan ch 2 ch 3 ch 1 ch 50 ch 5 scan pauses ch 4 for 10 seconds after the squelch opens, then resumes ■ Selecting a frequency The transceiver has 0.5 to 30.0 MHz general coverage receive capability, with 100 Hz resolution. Use the VFO mode to select frequencies around the preprogrammed channels in the memory mode. ☞ NOTE: Frequencies selected in the VFO mode are for temporary use and are not stored in memory. q While in the memory mode, rotate the [GROUP] and [CHANNEL] selectors to select the channel nearest the frequency you want. w Push [CH/FREQ] to select the VFO mode. • "FREQ" appears. e Rotate the [CHANNEL] selector to select the desired frequency. • The frequency changes in 100 Hz steps. SIMP SQL 1.6 MHz selected SIMP SQL 1.6001 MHz selected Rotate [CHANNEL] to select a frequency in 100 Hz steps 6