Icom IC-M700PRO Instruction Manual - Page 7

2 PANEL DESCRIPTION ■ Display ALM q RX w TUNE e TX !3 !2 !1 !0 DUP SIMP AGC o SQL NB i SCAN r t q RECEIVE INDICATOR Appears while receiving and when the squelch is open. w TUNE INDICATOR (p. 8) Flashes while the connected antenna tuner, such as Icom's AT-130, is being tuned. • Tuning starts when transmitting on a new frequency or pushing the [TUNE] switch. e TRANSMIT INDICATOR Appears when transmitting. r S/RF METER ➥ Shows the relative received signal strength while receiving. ➥ Shows output power while transmitting. t CHANNEL/VFO INDICATOR (p. 5) ➥ Shows the selected group and channel in the memory mode. ➥ "FREQ" appears in the VFO mode. y SQUELCH INDICATOR (p. 9) Appears when the squelch is ON. y u u SCAN INDICATOR (p. 6) Appears when the scan function is in use. • The scan function is not available on some versions. • Pushing [SCAN] starts and stops the scan. i NOISE BLANKER INDICATOR (p. 9) Appears when the [NB] switch is turned ON. o AGC OFF INDICATOR (p. 9) Appears when the [AGC] switch is pushed to indi- cate the AGC function is deactivated. !0 MODE READOUT Shows the selected operating mode (type of emis- sion). !1 SPEAKER OFF INDICATOR Appears when the [SPEAKER] switch is pushed to indicate the front panel speaker is deactivated. !2 FREQUENCY READOUT ➥ Shows the selected frequency whether in the memory mode or the VFO mode. (p. 5) ➥ Shows the transmit frequency (for duplex channels) when transmitting or when pushing [TX FREQ]. (p. 8) !3 SIMPLEX/DUPLEX INDICATORS These appear to show whether the selected chan- nel is simplex or duplex. • In the VFO mode, only simplex channels are available. • No indicator means that there is no transmit frequency programmed. 4