Icom IC-R20 Instruction Manual - Page 49

SCAN OPERATION 7 ■ Scan edges programming Scan edges can be programmed in the same manner as memory channels. Scan edges are programmed into scan edges, 00A/00B to 24A/24B, in memory channels. q Push [VFO MHz] to select VFO mode. w Set the desired frequency: ➥ Select the desired band with [BAND]. ➥ Set the desired frequency with [R-DIAL]. ➥ Set other data (e.g. offset frequency, duplex direction, tone squelch, etc.), if desired. ePush [MR S.MW] for 1 sec. to select select memory write condition. • 1 short and 1 long beeps sound. • "µ " indicator blinks. rRotate [R-DIAL] to select the desired programmed scan edge channel from 00A to 24A. t Push [MR S.MW] for 1 sec. • 3 beeps sound • The other scan edge channel "B," 00B to 24B, automatically selected when continuing to push [MR S.MW] after programming. yTo program a frequency for the other pair of scan edges, 00B to 24B, repeat steps w and r. • If the same frequency is programmed into a pair of scan edges, programmed scan will not function. 7 [R-DIAL] MR S.MW [EXAMPLE]: Programming 145.300 MHz into scan edges 03A. Push MR S.MW for 1 sec. Rotate Push MR S.MW for 1 sec. -DUP TSQL AFC MODE FM ANL 145 300 PSKIP √ µ 001 FM 146..010µ -BANK-:----BNAME: -MNAME: -SKIP-:OFF >CLEAR 001 FM . µ 03A -BANK-:---- -BNAME: -MNAME: -SKIP-:OFF >CLEAR -DUP TSQL AFC MODE FM ANL 145 300 PSKIP √ µ 03A -DUP TSQL AFC MODE FM ANL 145 300 PSKIP √ µ 020 36