Icom IC-R20 Instruction Manual - Page 57

D VFO scan watch q Select memory mode. • Select a memory bank, if desired. wPush [MODE SCAN] for 1 sec. to start memory/bank scan, if desired. While scanning memory/bank channels: Starts memory/bank scan first. Memory/bank scan cannot be started after VFO scan is started. e Push [8 SET] for 1 sec. to enter set mode. r Rotate [R-DIAL] to select "PRIO," then push [8 SET]. t Rotate to turn the priority watch ON, then push [8 SET]. • Select "BELL" if the priority beep function is necessary. y Push [DUALWATCH] to exit set mode and start the watch. • "PRIO" indicator appears. uPush and hold [MODE SCAN] to enter scan type selection condition. iRotate [R-DIAL] to select the desired scan type from "ALL," "BAND" and "PROG-xx (xx= 0-24)." o Release [MODE SCAN] to start the VFO scan watch. • The receiver checks the memory channel(s) every 5 sec. • The watch resumes according to the selected scan resume con- dition. (p. 41) !0 Push [DUALWATCH] to cancel the watch and scan. PRIORITY WATCH 8 • During priority watch -DUP TSQL AFC MODE FM ANL 1888 888 PSKIP √ PRIO µ 001 -DUP TSQL AFC MODE FM ANL 145 870 PSKIP √ PRIO µ 001 Monitors VFO frequency Pauses on a memory for 5 sec. (bank) channel when a signal is received. • During priority watch with priority beep 8 -DUP TSQL AFC MODE FM ANL 1888 888 -DUP TSQL AFC MODE FM ANL 145 870 PSKIP √ PRIO µ 001 PSKIP √ PRIO µ 001 Emits beep and blinks "S" indicator when a signal is received on a memory (bank) channel. 44