Icom IC-V3MR Instruction Manual - Page 14

3 BASIC OPERATION Turning ON the transceiver NOTE: Before using the transceiver for the first time, the battery pack must be fully charged for optimum life and operation. See "BATTERY CHARGING." (p. 5-1) zz Rotate [VOL] to turn ON the transceiver. [VOL] Selecting a channel DDSelecting an operating channel zz Rotate [Rotary Selector] to select an operating channel. Depending on the presetting, when the transceiver is turned ON, a scan automatically starts. The scan stops when a call is received. NOTE: When the Power SW ON function is turned ON, the Priority A channel is selected each time the transceiver is turned ON. In this case, the transceiver does not start scanning when it is turned ON. LLTo turn ON the Power SW ON function, set the following setting to "Enable" using the programming software. Common > Key & Display > Move to Prio A CH > Power SW ON DDAdjusting the audio level zz When receiving a call, rotate [VOL] to adjust the audio output level. DDDefault frequencies chart Channel Frequency (MHz) Ch 1 Ch 2 Ch 3 Ch 4 Ch 5 151.820 151.880 151.940 154.570 154.600 CTCSS Tone (Hz) 67.0 Band TX PWR Width (W) Narrow 2 Wide LLChannel 6 to 16 are not programmed by default. Ask your dealer for details. DDSelecting the Priority A or B channel zz Push [Prio A], [Prio A (Rewrite)], [Prior B], or [Prio B (Rewrite)] to select the Priority A or Priority B channel. DDRewriting the Priority A or B channel zz Hold down [Prio A (Rewrite)] or [Prio B (Rewrite)] for 1 second to set the currently selected channel as the Priority A or B channel. 3-2