Icom ID-1 Instruction Manual - Page 21
Type-n Connector Installation Example
View all Icom ID-1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Type-N CONNECTOR INSTALLATION EXAMPLE q Nut Rubber gasket 15 mm Slide the nut, washer, rubber gasket and clamp over the coaxial cable, then cut the end of the Washer cable evenly. w Clamp Center conductor Strip the cable and fold the braid back over the clamp. 3 mm 6 mm e Solder hole Soft solder the center conductor. Install the center conductor pin and solder it. No space r Carefully slide the plug body into place aligning the center conductor pin on the cable. Tighten the nut onto Be sure the center conductor is the same height as the plug body. the plug body. 15 mm ≈ 19⁄32 in 6 mm ≈ 1⁄4 in 3 mm ≈ 1⁄8 in 2 INSTALLATION AND CONNECTIONS 2 14
14
2
INSTALLATION AND CONNECTIONS
2
Type-N CONNECTOR INSTALLATION EXAMPLE
15 mm
≈
19
±
32
in
6 mm
≈
1
±
4
in
3 mm
≈
1
±
8
in
Slide the nut, washer,
rubber gasket and clamp
over the coaxial cable,
then cut the end of the
cable evenly.
Strip the cable and fold the
braid back over the clamp.
Soft
solder
the
center
conductor.
Install
the
center conductor pin and
solder it.
Carefully slide the plug
body into place aligning the
center conductor pin on the
cable. Tighten the nut onto
the plug body.
q
w
e
r
15 mm
3 mm
6 mm
No space
Solder hole
Be sure the center conductor is
the same height as the plug body.
Clamp
Center
conductor
Washer
Nut
Rubber gasket