Icom SAT100 Operating Manual
Icom SAT100 Manual
 |
View all Icom SAT100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Icom SAT100 manual content summary:
- Icom SAT100 | Operating Manual - Page 1
OPERATING MANUAL SATELLITE PTT iSAT100 INTRODUCTION 1 ACCESSORIES ATTACHMENTS 2 PANEL DESCRIPTION 3 BATTERY CHARGING 4 BASIC OPERATION 5 OTHER FUNCTIONS 6 HEADSET CONNECTION 7 MENU SCREEN 8 SPECIFICATIONS AND OPTIONS 9 TROUBLESHOOTING - Icom SAT100 | Operating Manual - Page 2
instructions for the IC-SAT100. READ also the BASIC MANUAL that is supplied with the transceiver. KEEP THE MANUALS, because it contains important operating information that may be useful in the future. Table of contents INTRODUCTION i ■■Important i 1 ACCESSORIES 1 ■■Supplied accessories - Icom SAT100 | Operating Manual - Page 3
the transceiver version. Attaching accessories DDAntenna Connect the supplied antenna to the antenna connector. CAUTION: ••DO NOT carry the transceiver by holding only the antenna. ••DO NOT connect an antenna other than the supplied antenna, or those listed in this manual. ••DO NOT transmit without - Icom SAT100 | Operating Manual - Page 4
1 ACCESSORIES Attaching accessories DDBattery pack/Battery case CAUTION: DO NOT attach or detach the battery pack or the battery case when the transceiver is wet or soiled. This - Icom SAT100 | Operating Manual - Page 5
1 ACCESSORIES Attaching accessories DDBelt clip To attach: 1. Detach the battery pack. 2. Slide the belt clip in the direction of the arrow until the belt clip is locked and - Icom SAT100 | Operating Manual - Page 6
and side panels 1 10 9 Antenna Connector 2 3 4 Microphone 8 7 6 5 Micro USB Connector Speaker 1 EMERGENCY KEY [EMER] Hold down to transmit an Emergency call. (p. 8) 2 PTT SWITCH [PTT] Hold down to transmit, release to receive. (p. 7) 3 P1/P2 KEYS [P1]/[P2] Push to use the function assigned - Icom SAT100 | Operating Manual - Page 7
strength level. NOTE: The antenna indicator " ˮ disappears if the connection with a satellite is not established. Keep the antenna vertical and wait until is active but no one is talking. REQUESTING Requesting a transmission. TALKING Transmitting LISTENING Receiving SCANNING Scanning a - Icom SAT100 | Operating Manual - Page 8
3 BATTERY CHARGING Battery charger NOTE: ••Before attaching or detaching a battery pack, BE SURE to turn OFF the transceiver by rotating [VOL] fully counter clockwise until it makes a "click" sound. Otherwise, a transceiver malfunction could occur. ••BE SURE to remove the transceiver from the - Icom SAT100 | Operating Manual - Page 9
Rotate Talkgroup selector to select a Talkgroup. L Push [Last Call] to playback the received call. (p. 9) L Push [UP] or [DOWN] to display the Talkgroup without an antenna. 1. Hold down [PTT]. • "REQUESTING" is displayed while the transceiver requests a transmission. 2. When "TALKING" is displayed - Icom SAT100 | Operating Manual - Page 10
transmit without an antenna. 1. Open the "Message List" in the Menu screen. [OK] > PTT Options > Message the transmission. 2. W hen "TALKING" is displayed, the transceiver transmits the keypad* when no key is pushed for 30 seconds. * E xcept for [EMER], [PTT], [VOL], and Talkgroup selector. - Icom SAT100 | Operating Manual - Page 11
the Status indicator do not light, even when a signal is received, or a key is pushed. 1. Assign the function to the [P1] key in the Menu screen. [OK] > 6 latest calls. LLConfirm the Call Recorder function is turned ON. ([OK] > PTT Options > Call Recorder) 1. Assign the function to the [P1] key in - Icom SAT100 | Operating Manual - Page 12
. LLPush [BACK] to cancel searching. 3. Select the headset to pair and connect, and then push [OK]. LLA passkey or PIN code may be required to pair, depending on the headset. Refer to your headset or device's instructions for details. 4. H old down [BACK] for 1 second to exit the Menu screen is - Icom SAT100 | Operating Manual - Page 13
in the transceiver may differ, depending on the its version or presettings. Menu Talkgroup PTT Options Bluetooth Functions Clock Menu items DDTalkgroup Refresh Talkgroup Select the item, and then push [OK] to refresh the Talkgroup list. Talkgroup List Displays the Talkgroup list. LL"P" is - Icom SAT100 | Operating Manual - Page 14
device. ••OFF: The user must manually connect to a bonded device. ••ON: device information such as the device name, address, support profile, version, and so on. Key Beep push of the VS-3's [PTT]. ••OFF: Push [PTT] to transmit and release to receive. ••ON: Push [PTT] to transmit and push - Icom SAT100 | Operating Manual - Page 15
Select a Backlight setting. ••OFF: The backlight is always OFF. ••ON: The backlight is always ON. ••Auto: When any switch except [PTT] is pushed, the backlight lights for 5 seconds. Contrast Adjust the contrast level. Language Select a Language for the user interface. DDBeep/Vibration Sets - Icom SAT100 | Operating Manual - Page 16
transceiver vibrates when received an Emergency call. Key Vibration Turn the key vibration ON or OFF. The transceiver vibrates when you pushed any key except [PTT]. Receive Vibration Turn the receive vibration ON or OFF. The transceiver vibrates when received any call or message. Opening Vibration - Icom SAT100 | Operating Manual - Page 17
notice or obligation. DDGeneral ••Frequency range: ••Number of channels: ••Type of emission: ••Duplexing method: ••Multiplexing method: ••Antenna impedance: ••Input impedance (MIC): ••Output impedance (audio): ••Operating temperature range: ••Power supply voltage: ••Current drain: ••Dimensions - Icom SAT100 | Operating Manual - Page 18
a [PTT] switch. About the third party Bluetooth® headsets: Icom has checked the PTT operation SAT100 APPLICATION SOFTWARE The RS-SAT100 is an application that enables you to text chat through a satellite communication network by connecting a satellite transceiver. See the RS-SAT100 INSTRUCTIONS - Icom SAT100 | Operating Manual - Page 19
equipment. This could be life endangering. BE CAREFUL not to pinch your finger when you attach the antenna. DO NOT put the antenna near a clock, television set (CRT type), magnetic compass or any magnetic/IC cards, credit cards, and so on. The magnet base may cause the products to malfunction or may - Icom SAT100 | Operating Manual - Page 20
is the option consists of 4 parts. This connector enables attaching/detaching the AH-40 antenna with inserting the transceiver to the BC-247 docking station, as shown below. Example of use: Antenna Connector of the AH-40 Adapter Adapter Attach the Gooseneck, and then insert the transceiver - Icom SAT100 | Operating Manual - Page 21
9 TROUBLESHOOTING Troubleshooting PROBLEM POSSIBLE CAUSE SOLUTION The transceiver does ••The p. 4 ••Recharge the battery pack. p. 6 ••Retry transmitting in a place without p. 7 obstacles. ••Push [P2] until "Lock OFF" is displayed p. 4 to turn OFF the function. ••Adjust the key beep - Icom SAT100 | Operating Manual - Page 22
A7517-3EX-4 © 2019-2021 Icom Inc. Jan. 2021 1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003, Japan
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
 |
 |
OPERATING MANUAL
9
TROUBLESHOOTING
7 MENU SCREEN
6 HEADSET CONNECTION
5 OTHER FUNCTIONS
4 BASIC OPERATION
3 BATTERY CHARGING
2 PANEL DESCRIPTION
1 ACCESSORIES ATTACHMENTS
INTRODUCTION
iSAT100
SATELLITE PTT
8
SPECIFICATIONS AND OPTIONS