Icom SAT100 Operating Manual - Page 16

7 MENU SCREEN Menu items TIP: When you set the beep level to between "1 (Linked)" and "5 (Linked)," you can adjust the beep level within the range of 0 and selected level by rotating [VOL]. System Beep Lv Sets the system beep output level. The beep sounds when connecting to or blocked from the system. Emer Beep Lv Sets the beep output level when in the Emergency mode. Key Beep Lv Sets the key beep output level. Ringer Lv Sets the ringer output level. Opening Beep Lv Sets the opening beep output level. The transceiver beeps when it is turned ON. Displays the battery information such as voltage, battery percentage, cycle count, and so on. RSSI Displays the Received Signal Strength Indication (RSSI). My Position Displays your current position. Firmware Info Displays the transceiver's firmware information. Satellite Info Displays satellite information. Certification Displays the certifications acquired with the transceiver. System Vibration Turn the system vibration ON or OFF. The transceiver vibrates when connecting to or blocked from the system. Emer Vibration Turn the Emergency vibration ON or OFF. The transceiver vibrates when received an Emergency call. Key Vibration Turn the key vibration ON or OFF. The transceiver vibrates when you pushed any key except [PTT]. Receive Vibration Turn the receive vibration ON or OFF. The transceiver vibrates when received any call or message. Opening Vibration Turn the opening vibration ON or OFF. The transceiver vibrates when it is turned ON. DDInformation Battery Info 14