Image Fitness 4.0 Ex Bike Uk Manual - Page 17

MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the exercise cycle regularly. Replace any worn parts immediately. To clean the exercise cycle, use a damp cloth and a small amount of mild soap. Important: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. HOW TO MOVE THE EXERCISE CYCLE To move the exercise cycle, stand behind it and lift the frame in the location shown below. To reduce the risk of injury, bend your legs and keep your back straight. As you lift the frame, make sure to lift with your legs rather than your back. Carefully move the exercise cycle on the front wheels, and then lower the frame. Lift Here Wheel HOW TO LEVEL THE EXERCISE CYCLE After the exercise cycle has been moved to the location where it will be used, make sure that both ends of front stabiliser are touching the floor. Leveling Foot If the exercise cycle rocks slight- ly during use, turn one or both of the leveling feet under the front stabiliser until the rocking motion is eliminated. HANDGRIP PULSE SENSOR TROUBLESHOOTING • Avoid moving your hands whilst using the handgrip pulse sensor. Excessive movement may interfere with heart rate readings. • Do not hold the metal contacts too tightly; doing so may interfere with heart rate readings. • For the most accurate heart rate reading, hold the metal contacts for about 30 seconds. • For optimal performance of the handgrip pulse sensor, keep the metal contacts clean. The contacts can be cleaned with a soft cloth; never use alcohol, abrasives, or chemicals. BATTERY REPLACEMENT If the console is using battery power, and if the displays becomes dim, the batteries should be replaced. Most console problems are the result of low batteries. See assembly step 11 on page 9 for replacement instructions. 17