Insignia NS-1DVDR User Manual (English) - Page 26
Maintaining
View all Insignia NS-1DVDR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
The remote There is an obstacle control does in the path of the not work remote control and correctly your recorder. Remove the obstacle. The batteries in the remote control are exhausted. Replace the batteries with new ones. The remote control is not pointed at the remote sensor of your recorder. Point the remote control at the remote sensor of your recorder. The remote control is Operate the remote control too far from your within 23 ft (7 m). recorder. Timer The recorder clock is Set the clock to the correct recording is not set to the correct time. not possible time. The timer has been programmed incorrectly. Reprogram the timer. The TIMER Record indicator light does not appear after programming the timer. Reprogram the Timer and turn off your recorder to enable the timer. Cannot play disc a recorded on your recorder on another DVD player The disc was recorded in Video mode. Some players will not play even a finalized disc recorded in Video mode. Finalize the disc. See "Disc Settings" on page 12. No solution. The disc was The other player must be RW recorded in VR mode. compatible in order to play the disc. Discs recorded with copy-once material cannot be played on other players. No solution. Cannot record or did not record successfully Not enough blank space remaining on the disc. Use another disc. The source you are trying to record is copy-protected. You cannot record the source. When recording to a Video mode disc, programs that are copy-once protected cannot be recorded. Use a VR mode formatted disc for copy-once material. Maintaining Care and handling of discs Handling discs Do not touch the playback side of the disc. Hold the disc by the edges so that fingerprints do not get on the surface. Never stick paper or tape on the disc. Storing discs After playing, store the disc in its case. Do not expose the disc to direct sunlight or sources of heat and never leave it in a parked car exposed to direct sunlight. Cleaning discs Fingerprints and dust on the disc can cause poor picture quality and sound distortion. Before playing, clean the disc with a clean cloth. Wipe the disc from the center out. Do not use strong solvents such as alcohol, benzine, thinner, commercially available cleaners, or anti-static spray intended for older vinyl records. Note Never operate this product immediately after moving it from a cold location to a warm location. Leave it for two or three hours without operating it. If you use this product in such a situation, it may damage discs or internal parts. Resetting your recorder Reset your recorder if you observe any of the following symptoms: • When your recorder is plugged in, but the power will not turn on or off. • When the display window does not working. • When your recorder does not operate normally. To reset your recorder: • Press and hold the POWER button for more than five seconds. This forces your recorder to turn off. Press the POWER button again to turn your recorder back on. Or, unplug the power cord and then plug the power cord again after more than five seconds. 24 www.insignia-products.com