Insignia NS-LTDVD32-09 User Manual (English) - Page 34
Specifications, Legal notices - power on problems
View all Insignia NS-LTDVD32-09 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Insignia NS-LTDVD32-09 32" LCD TV/DVD Combo Problem Solution Stripes on picture Check for interference from other electronic devices, such as radios and televisions, and keep magnetic or electronic devices away from your TV. Bad stereo or SAP sound A long broadcast distance, or interference from radio waves, can cause bad sound reception. If so, change the mode to Mono. Remote control Remove obstacles between the remote control does not work and the player. Point the remote control at your TV's IR sensor. Install fresh batteries. "Unsupported" appears on the screen. Check the resolution and frequency of your computer, and adjust it to the optimum resolution for this TV: 1360 × 768 at 60Hz. "No Signal" appears on the screen Make sure that the cable is firmly connected to the computer and TV. Image is not clear Adjust the phase control. Image is not centered Adjust the horizontal control. Picture has a few A few bright or dark dots on an LCD screen is bright or dark normal. It does not affect the operation of this dots TV. DVD Problem Solution No sound No image Bad sound quality Disc cannot be played The player doesn't operate normally Remote control does not work • Make sure that your TV or amplifier is working correctly. • Make sure that the amplifier is set to receive DVD signal output. • Make sure that your TV is working correctly. • Make sure the color system is set correctly. • Make sure that the audio output mode is set correctly. • Make sure that the audio connection between your TV and amplifier (if used) is secure. • Make sure that the disc is inserted with the label facing forward. • Clean the disc. • Moisture has condensed in the player. Remove the disc and leave the player on for about an hour to dry out. Disconnect the power plug, then reconnect it. • Remove obstacles between the remote control and the player. • Point the remote control at your TV's IR sensor. • Install fresh batteries. Specifications LCD Panel 32" WIDE TFT LCD Resolution 1360 × 768 Viewing angle 170°/170° Contrast ratio 800:1(Typ.) Brightness (cd/m2) 500 Dimensions Weight TV Power Sound Terminals DVD player Operating conditions With stand Without stand TV standard Tuning system Frequency range Stereo CATV Input Consumption (Max.) Output A/V in Component PC in HDMI Antenna in Signal System Playable discs Temperature Humidity Atmospheric pressure 31.3 × 22.7 × 11 in. (795 × 576 × 280 mm) 31.3 × 21 × 3.3 in. (795 × 533 × 85 mm) 34.57 lbs. (15.68 kg) ATSC/NTSC Electronic tuning system VHF/UHF BTSC 135 channels, QAM channels 100-240V AC, 50/60 Hz 200 W 7 W×2 Video, S-Video, Audio L/R Y, Pb (Cb), Pr (Cr) D-SUB 15-pin RGB in HDMI compliant (type A connector) F-type NTSC DVD:12cm CD:12cm 5°C~35°C 20%~80% RH 86KPa~106 KPa Legal notices FCC Part 15 This device complies with Part 15 of the FCC Rules. Operation of this product is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply within the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced technician for help. Macrovision statement This product incorporates copyright protection technology that is protected by method claims of certain U.S. patents and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be authorized by Macrovision Corporation, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited. 34 www.insignia-products.com