Insignia NS-R2001 User Manual (English) - Page 12

NS-R2001_10-1254_MAN_ENG.book Page 10 Friday, February 11, 2011 7:43 AM Insignia NS-R2001 AM/FM Stereo Receiver -OREnter the preset number using the numeric keypad. Note When using the numeric keypad on the remote control, press the number you want. If your number is greater than nine, enter the first digit, then enter the second digit within two seconds. Scanning preset stations in sequence To scan preset stations: 1 Press the PRESETS button on the remote control. Note Each time this button is pressed, the FM mode changes as follows: • Stereo mode-ST lights up • Mono mode-ST turns off. Note If an FM stereo broadcast is poor, due to a weak broadcast signal, select the FM mono mode to reduce the noise. The FM broadcasts are reproduced in monaural sound. Recording Notes • • The volume, tone (bass and treble), and balance settings have no effect on the recording signals. When you select tuner, CD, or PHONO as a recording source, recording may be made on AUX 1, or AUX 2, or both simultaneously. Recording on AUX 1 To record on AUX 1: 1 Select the recording input source (this cannot be AUX 1). The receiver starts scanning the stations in the preset sequence. Each station is sampled for five seconds. Note Stations with weak signals will not be scanned, and will therefore not be sampled. 2 Press the PRESETS button again to stop scanning. Listening to FM stereo broadcasts To listen to FM stereo broadcasts: • While listening to an FM broadcast, press the MONO/STEREO button. OR 2 Start recording on the AUX 1 device. 3 Start play on your input device. 10 www.insigniaproducts.com