Insignia NS-TDRE67W1 User guide - Page 24
Installing your dryer, Tools you will need, Before you start
View all Insignia NS-TDRE67W1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
INSTALLATION INSTRUCTIONS 6 Attach aluminum tape to the back of the dryer to seal the original dryer vent hole. Aluminum tape Elbow Installing your dryer Important: We recommend that you use a qualified installer to install your dryer. Tools you will need Phillips screwdriver Level Flat-head screwdriver Aluminum tape Pliers Pipe wrench Adjustable wrench that opens to 1" (2.5 cm) Cutting knife Materials you will need • 3/8" gas dryer gas line (Gas model only) • Three- or four-prong (dependent on owner's house) electric power cord (electric model only) • Exhaust dryer vent kit Before you start Before you start installing your dryer, make sure that: • The location you selected has a grounded electrical outlet. See Grounding requirements on page 20. • For U.S. models, you have the correct type power cord (not included). See Electric requirements on page 17. Note: For Canadian models, the power cord comes pre-installed. • Your dryer vent is in the correct location. See "Changing the dryer vent location (optional)" on page 21 to change where your dryer vents. • Your exhaust ducting (not included) is made of rigid metal or semi-rigid metal. See Duct requirements on page 16. • You have a 3/8 in. (1 cm) gas dryer gas line (if you are installing a gas dryer) that meets all national and local codes. Before you connect the gas line, review the gas line requirements in Gas requirements on page 19. 24 www.insigniaproducts.com