Insignia NS-TDRE67W1 User guide - Page 27
Uncoated copper tubing will corrode when subjected to natural gas, causing
View all Insignia NS-TDRE67W1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
INSTALLATION INSTRUCTIONS 12-Cycle Electric and Gas Dryers 2 Connect all the pipe joints and tighten with a wrench. Note: An additional fitting is required to connect the 3/4 in. (1.9 cm) female thread end of a flexible connector to the 3/8 in. (1 cm) male threaded end on the dryer. Use only new AGA or CSA certified gas supply line with SS flexible connectors. The National Fuel Gas Code requires that an accessible, approved manual gas shutoff valve be installed within 6 in. (15 cm) of your dryer. Manual shutoff valve Flare union Flare union Nipple Flexible connector 3 Apply a pipe joint compound or about 1.5 in. wraps of teflon tape over all threaded connections. The pipe joint compound must be resistant to the actions of any liquefied petroleum gas. 4 Connect the gas supply to your dryer. Inlet pipe on back of dryer 5 Securely tighten the gas line fitting over the threads. 6 Turn on the gas supply. Open WARNING: • All gas installations of the dryer must be equipped with Manual Shut-Off valve. • Uncoated copper tubing will corrode when subjected to natural gas, causing gas leaks. Use ONLY black iron, stainless steel, or plastic-coated brass piping for gas supply. • Check all gas connections for leaks using a soap solution. • If bubbles appear, tighten the connections and recheck. DO NOT use an open flame to check for gas leaks. www.insigniaproducts.com 27