Intel D925XHY English Product Guide - Page 38

Connecting the IDE Cable

Get Intel D925XHY PDF manuals and user guides View all Intel D925XHY manuals
Add to My Manuals
Save this manual to your list of manuals

Page 38 highlights

Intel Desktop Board D925XHY Product Guide Connecting the IDE Cable The IDE cable can connect two drives to the desktop board. The cable supports the ATA-66/100 transfer protocol. Figure 18 shows the correct installation of the cable. NOTE ATA-66/100 compatible cables are backward compatible with drives using slower IDE transfer protocols. If an ATA-66/100 disk drive and a disk drive using any other IDE transfer protocol are attached to the same cable, the maximum transfer rate between the drives may be reduced to that of the slowest drive. NOTE Do not connect an ATA device as a slave on the same IDE cable as an ATAPI master device. For example, do not connect an ATA hard drive as a slave to an ATAPI CD-ROM drive. For correct function of the cable: 1. Observe the precautions in "Before You Begin" on page 23. 2. Attach the cable end with the single connector to the Intel desktop board (Figure 18, A). 3. Attach the cable end with the two closely spaced connectors to the drives (Figure 18, B). A Figure 18. Connecting the IDE Cable B OM19125 38

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
Intel Desktop Board D925XHY Product Guide
38
Connecting the IDE Cable
The IDE cable can connect two drives to the desktop board.
The cable supports the ATA-66/100
transfer protocol.
Figure 18 shows the correct installation of the cable.
NOTE
ATA-66/100 compatible cables are backward compatible with drives using slower IDE transfer
protocols.
If an ATA-66/100 disk drive and a disk drive using any other IDE transfer protocol are
attached to the same cable, the maximum transfer rate between the drives may be reduced to that of
the slowest drive.
NOTE
Do not connect an ATA device as a slave on the same IDE cable as an ATAPI master device.
For
example, do not connect an ATA hard drive as a slave to an ATAPI CD-ROM drive.
For correct function of the cable:
1.
Observe the precautions in "Before You Begin" on page 23.
2.
Attach the cable end with the single connector to the Intel desktop board (Figure 18, A).
3.
Attach the cable end with the two closely spaced connectors to the drives (Figure 18, B).
A
B
OM1
9
125
Figure 18.
Connecting the IDE Cable