Intel DB75EN Technical Product Specification - Page 53
Alternate Front Panel Power/Sleep LED Header
View all Intel DB75EN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Technical Reference 2.2.2.4.3 Power/Sleep LED Header Pins 2 and 4 can be connected to a one- or two-color LED. Table 27 shows the possible states for a one-color LED. Table 28 shows the possible states for a two-color LED. Table 27. States for a One-Color Power LED LED State Description Off Steady Green Power off/sleeping Running Table 28. States for a Two-Color Power LED LED State Description Off Power off Steady Green Running Steady Yellow Sleeping NOTE The colors listed in Table 27 and Table 28 are suggested colors only. Actual LED colors are chassis-specific. 2.2.2.4.4 Power Switch Header Pins 6 and 8 can be connected to a front panel momentary-contact power switch. The switch must pull the SW_ON# pin to ground for at least 50 ms to signal the power supply to switch on or off. (The time requirement is due to internal debounce circuitry on the board.) At least two seconds must pass before the power supply will recognize another on/off signal. 2.2.2.5 Alternate Front Panel Power/Sleep LED Header Pins 1 and 3 of this header duplicate the signals on pins 2 and 4 of the front panel header. Table 29. Alternate Front Panel Power/Sleep LED Header Pin Signal Name 1 POWER_LED_MAIN 2 Key (no pin) 3 POWER_LED_ALT Description [Out] Front panel LED (main color) [Out] Front panel LED (alt color) 53