Intel DG965RY Product Specification - Page 48
Connectors and Headers
View all Intel DG965RY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Intel Desktop Board DG965RY Technical Product Specification Table 16. PCI Interrupt Routing Map ICH8 PIRQ Signal Name PCI Interrupt Source ICH8 LAN PCI bus connector 1 PIRQA PIRQB PIRQC PIRQD PIRQE INTA INTD PIRQF INTA PIRQG INTB PIRQH INTC PCI bus connector 2 INTC INTB INTA INTD PCI bus connector 3 INTD INTC INTA INTB IEEE-1394a controller INTA NOTE In PIC mode, the ICH8 can connect each PIRQ line internally to one of the IRQ signals (3, 4, 5, 6, 7, 9, 10, 11, 12, 14, and 15). Typically, a device that does not share a PIRQ line will have a unique interrupt. However, in certain interrupt-constrained situations, it is possible for two or more of the PIRQ lines to be connected to the same IRQ signal. Refer to Table 14 for the allocation of PIRQ lines to IRQ signals in APIC mode. PCI interrupt assignments to USB ports and Serial ATA ports are dynamic. 2.8 Connectors and Headers CAUTION Only the following connectors have overcurrent protection: Back panel and front panel USB, PS/2, and VGA. The other internal connectors/headers are not overcurrent protected and should connect only to devices inside the computer's chassis, such as fans and internal peripherals. Do not use these connectors/headers to power devices external to the computer's chassis. A fault in the load presented by the external devices could cause damage to the computer, the power cable, and the external devices themselves. This section describes the board's connectors and headers. The connectors and headers can be divided into these groups: • Back panel I/O connectors (see page 49) • Component-side connectors and headers (see page 50) 48