Intel R2000LH2/LT2 Service Guide - Page 14

Server System Features Feature Internal I/O connectors/headers Description  USB 2.0 connectors - 4 on back panel + 2 on front panel  One Type-A USB 2.0 connector  One internal USB header  One DH-10 Serial-B port connector Optional I/O Module Support System Fans The following I/O modules utilize a single proprietary on-board connector. An installed I/O module can be supported in addition to standard on-board features and any add-in expansion cards.  Quad port 1 GbE based on Intel® Ethernet Controller I350  Dual port 10GBase-T Ethernet module based on Intel® Ethernet Controller I350 - AXX10GBTWLIOM  Dual SFP+ port 10GbE module based on Intel® 82500 10 GbE controller - AXX10GBNIAIOM  Single Port FDR speed InfiniBand* module with QSFP connector - AXX1FDRIBIOM  Eleven managed system fans  One power supply fan for each installed power supply module Riser Cards Video On-board storage controllers and options Support for two riser card slots. Each riser card slot has support for three PCIe x16 slots  Integrated 2D Video Controller  16 MB DDR3 Memory  One low-profile eUSB 2x5 pin connector to support low-profile eUSB solid state devices  Two single port SATA connectors capable of supporting up to 6 GB/sec  Two 4-port mini-SAS connectors capable of supporting up to 3 GB/sec SAS/SATA  Intel® RAID C600 Upgrade Key support providing optional expanded SATA/SAS RAID capabilities Security Server Management Power Supply Options Storage Bay Options Rack Mount Kit Options Trusted Platform Module (Optional)  Integrated Baseboard Management Controller, IPMI 2.0 compliant  Support for Intel® Server Management Software (version TBD)  Intel® Remote Management Module 4 support (optional)  Intel® Remote Management Module 4 Lite support (optional) The system is shipped with two power supplies with support below options.  1600W (1+1) Redundant Hot-swap Capable  1600W (1+0 or 2+0) Non-Redundant  4" x 3.5" SATA/SAS Hot Swap Hard Drive Bays + Optical Drive support  8" x 2.5" SATA/SAS Hot Swap Hard Drive Bays  Extended Value rack mount rail kit (AXXELVRAIL)  Premium rack mount rail kit (AXXPRAIL), will be available at post launch CAUTION: THE MAXIMUM RECOMMENDED SERVER WEIGHT FOR THE RACK RAILS CAN BE FOUND at http://www.intel.com/support/motherboards/server/sb/CS-033655.htm. EXCEEDING THE MAXIMUM RECOMMENDED WEIGHT OR MISALIGNMENT OF THE SERVER MAY RESULT IN FAILURE OF THE RACK RAILS HOLDING THE SERVER. Use of a mechanical assist to install and align server into the rack rails is recommended. 2 Intel® Server System R2000LH2/LT2 Service Guide