Intel S3000PT Product Specification - Page 23

Intel® Server Board S3000PT TPS Functional Architecture Table 6. Characteristics of Dual/Single Channel Configuration with or without Dynamic Mode Throughput Level Highest Configuration Dual channel with dynamic paging mode Dual channel without dynamic paging mode Lowest Single channel with dynamic paging mode Single channel without dynamic paging mode Characteristics All DIMMs matched DIMMs matched from Channel A to Channel B DIMMs not matched within channels Single DIMM or DIMMs matched within a channel DIMMs not matched 3.3.1 Memory DIMM Support The board supports un-buffered (not registered) DDR2 533/667 ECC DIMMs operating at 533/667MT/s. Only DIMMs tested and qualified by Intel o r a designated memory test vendor are supported on this board. A list of qualified DIMMs is available at http://support.intel.com/support/motherboards/server/ . Note: All DIMMs are supported by design, but only fully qualified DIMMs will be supported on the board. The minimum supported DIMM size is 256 MB. Therefore, the minimum main memory configuration is 1 x 256 MB or 256 MB. The largest size DIMM supported is 2 GB and as such, the maximum main memory configuration is 8 GB implemented by 4 x 2-GB DIMMs.  Only un-buffered DDR2 533/667 compliant, ECC x8 or x16 memory DIMMs are supported.  ECC single-bit errors (SBE) will be corrected; multiple -bit error (MBE) will only be detected.  Intel® Server Board S3000PT supports Intel® x4 Single Device Data Correction with x4 DIMMs.  The maximum memory capacity is 8 GB via four 2 -GB DIMM modules.  The minimum memory capacity is 256 MB via a single 256-MB DIMM module. 3.4 I/O Sub-System 3.4.1 PCI Subsystem There are three independent PCI bus segments directed from the Intel® ICH7R controller on the Intel® Server Board S3000PT. PCI Segment A is a legacy PCI bus while PCI Segments B and C are PCI Express*. Revision 1.3 15