Intel SE7500WV2 Product Guide - Page 29
Connect Power Cables, Install the Fan module
UPC - 735858157049
View all Intel SE7500WV2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Connect Power Cables 1. Verify that the P6 backplane power cable is routed from the power supply to the backplane board and is connected to the white 6-pin connector. 2. Connect the main server board power cable to the white 24-pin connector on the server board. Firmly press the two connectors together until they are fully seated. B B A OM14616 Figure 13. Connecting the Main Power Cable Install the Fan module CAUTION When installing the fan module, avoid pinching cables routed in the area. 1. Note the raised tabs on the chassis floor and the corresponding holes in the bottom of the fan module. 2. Lower the fan module until it is just above the chassis floor. 3. Align the holes in the fan module with the raised tabs on the chassis and lower the fan module onto the floor. 4. While pressing down on the fan module, slide it in the direction of arrow (2) until the latch snaps into place. Assembling the System 29