Intel STL2 Quick Start Guide - Page 21

Install the Server Board The screws for installing the server board are shipped with the chassis. You may need to move cables out of the way to properly install your server board. 1 Tilt the board into the chassis I/O connector end first. Position the board so the screw holes line up with the standoffs. There are two positioning standoffs that extend into the holes on the server board. These two standoffs will help you position the board correctly. Make sure the I/O connectors stick out through the I/O shield. Look through the holes in the I/O shield to make sure that the metal tabs on the I/O shield are on top of the USB and NIC connectors, not inside the connectors. 2 Insert one screw through one of the mounting holes of the board and into a threaded standoff. Do not tighten the screw until the next step. 3 Insert the remaining screws through the mounting holes and into the threaded standoffs. Make sure the board is properly seated, then tighten all the screws firmly, starting with the screws in the center of the board. Intel Server Board STL2 Quick Start Guide OM10684 21