Intel STL2 Quick Start Guide - Page 5
Common Problems, The system does not boot or show video at power on., The system sometimes works
UPC - 735858140256
View all Intel STL2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Common Problems The system does not boot or show video at power on. • If configuring with only one processor verify that the processor is in the Primary Processor socket and the terminator is in the Secondary Processor socket. (See the server board components diagram on page 6). • Beep code 1-3-3-1 means you have unrecognized or bad memory. Remove DIMMs one at a time to isolate which one is causing problems. • Your power supply must provide 0.8 A of +5 V Standby current to support WOL. If the standby current is not present, your board will not boot. The system sometimes works, but is exhibiting erratic behavior. • This is typically the result of using a under-powered power supply. Make sure it's at least a 300 W power supply. Intel Server Board STL2 Quick Start Guide 5