Intermec 6822 6820 Printer Installation Instructions - Page 14

2 Remove the paper backing from a clamp (P/N: 807-059-001) and stick the clamp in place while drilling a pilot hole with a #26 drill bit. Use #6 sheet-metal screws to permanently hold clamps in place. Grounding the Printer Power Cables The printer power cable has a ground strap that must fasten to vehicle sheet-metal to ensure proper cable shielding. This ground strap is the wire with a ring terminal by the white connectors between the DC power cable and the vehicle battery cable. To fasten the ground strap: 1 Drill a small hole (slightly smaller than the screw diameter) where to fasten the chassis ground strap for the power cable connector. Use a punch to dimple and enlarge the hole. 2 Scrape a small circle of paint from around the hole to ensure a good electrical connection. 3 Use a #8 x 5/8" screw and flat washer to secure the strap. 14 6820 Printer Installation Instructions