Intermec CV41 Intermec Terminal Emulator (ITE) User Guide - Page 78

Chapter 2 - Configuring and Managing ITE Enabling the Configuration Menu Password By default, you do not need to enter a password to access the ITE Main Menu. You can enable password protection to prevent unauthorized access. You can set a different password for each session. To enable this password, see "Configuring Options for Each Session" on page 23. Enabling License Check-Out If you use SmartSystems Foundation to manage Intermec devices, by default ITE checks an ITE license out from the SmartSystems server when the application is launched. When you close ITE (using the menus or the Exit button in the Toolbar), the application tries to check its license back in to the license pool. • If ITE cannot communicate with the server at shutdown time, the computer keeps the license, and ITE tries to check the license in the next time ITE is closed. • If you suspend the computer without closing ITE, the computer keeps the license until you close ITE. • If you warm boot the computer while ITE is running, the computer keeps the license. After the warm boot is done, ITE starts with the same license as before. You can disable license check-in if: • you want to assign one license to each computer running ITE, eliminating the need to check licenses out or in. • the SmartSystems server is difficult to reach, or on a subnet used only for setup. To configure ITE license check-out 1 Open the Intermec Terminal Emulation main menu in Intermec Settings. For help, see "To configure ITE directly on the computer" on page 21. 2 Tap Chk In License. 3 Select Chk In License to enable this feature, and then tap OK to save your changes. Or, tap Cancel to return to the ITE main menu without enabling license check-in. For general information on ITE licensing, see "About ITE Licensing" on page 2. 66 Intermec Terminal Emulator (ITE) User Guide