Intermec PX4i Printer 802.11 Radio Interface Kit Installation Instructions - Page 4
power cord and communication cables., Before you begin, turn off the printer and disconnect
View all Intermec PX4i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
To install the 802.11 interface, you need to open the printer and physically install the interface board in the printer. This interface kit must only be installed by an authorized service technician. The device is country/region specific and must be ordered for the correct country/region. Use of this device in other region than shown on the device home page/test label may violate applicable law. Follow standard ESD guidelines to avoid damaging the equipment you are servicing. Before you begin, turn off the printer and disconnect the power cord and communication cables. The electronic compartment contains wires and components with dangerous voltage (up to 380 V). Make sure that the printer is switched off and the power cord is disconnected before the cover is removed. 4 Printer 802.11 Radio Interface Kit Installation Instructions