Invacare RECLSYS Owners Manual 2 - Page 113
Electronics
View all Invacare RECLSYS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 113 highlights
SECTION 13-ELECTRONICS SECTION 13-ELECTRONICS ƽ WARNING After ANY adjustments, repair or service and BEFORE use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result. Preparing MKIV Joystick for Use NOTE: For this procedure, refer to FIGURE 13.1. NOTE: The MKIV joystick is factory installed on the right side of the wheelchair. To reposition the MKIV joystick onto the left side of the wheelchair, refer to Repositioning MKIV Joystick on page 113. 1. Turn the adjustment lock lever to release the adjustment lock from joystick mounting tube. MKIV Joystick 2. Slide joystick mounting tube to the desired position. 3. Turn the adjustment lock lever to secure the adjustment lock to the joystick mounting tube. Joystick Mounting Tube Adjustment Lock w/ Lever FIGURE 13.1 Preparing MKIV Joystick for Use Repositioning MKIV Joystick NOTE: For this procedure, refer to FIGURE 13.2. 1. Turn the adjustment lock lever to release the joystick mounting tube from the mounting bracket. 2. Remove the joystick from the wheelchair. Washers Mounting Bracket (Threaded Plate) Arm Tube 3. Remove the three hex screws that secure the both halves of the mounting bracket to the arm tube. 4. Reposition mounting bracket on opposite arm tube ensuring the threaded plate of the mounting bracket is on the inside of the arm tube as shown in FIGURE 13.2. Hex Mounting Mounting Bracket Screws Joystick Adjustment Mounting Lock Lever Tube MKIV-RII Joystick FIGURE 13.2 Repositioning MKIV Joystick 5. Using the three hex mounting screws and washers, secure both halves of the mounting bracket to the arm tube. 6. Slide the joystick mounting tube through the mounting bracket to the desired position. 7. Turn the adjustment lock lever to secure the joystick mounting tube into the mounting bracket. Part No 1134791 113 3G Storm Series® Wheelchairs