Invacare RECLSYS Owners Manual 2 - Page 54

SECTION 5-WHEELCHAIR OPERATION Seating Systems with the TRCM Actuator Control SEATING SYSTEM FOUR-WAY TOGGLE SWITCH FORWARD REAR LEFT RIGHT Tilt/Elevate** Increase/ Decrease the Tilt Angle* Elevate/Lower the Seat* Raise/Lower N/A Power Legrests* NOTE: If the wheelchair is equipped with switch options, scan to the correct ECU or Auxiliary Mode and activate the control device in the corresponding "forward" direction to operate the tilt function. Refer to the Electronics Service Manuals listed in Reference Documents on page 2 for complete switch option operating instructions. *NOTE: The four-way toggle switch will alternate functions (increase tilt angle, decrease tilt angle) after it has been released to the neutral position for a minimum of five seconds. Refer to the Electronics Service Manual listed in Reference Documents on page 2 for complete four-way toggle switch operating instructions. **NOTE: The seat MUST be tilted/reclined so the back angle is less than 20° relative to the vertical position before elevating/lowering the seat. 3. Release four-way toggle switch to neutral position. Four-Way Toggle Switch Rear Left LED Right Forward FIGURE 5.3 Optional Four-Way Toggle Switch Vernier Shear Reduction (2G Tarsys Systems Only) NOTE: For this procedure, refer to FIGURE 5.3 on page 54. About Vernier Shear Reduction ƽ WARNING The relationship between Vernier Shear Reduction (VSR) and the recline function of the seating system is dependent on the needs of the user and MUST be set and adjusted by a trained qualified technician. Have the relationship between Vernier Shear Reduction (VSR) and the recline function of the seating system periodically inspected to maintain proper setting for the user. Otherwise injury to the user may result. 3G Storm Series® Wheelchairs 54 Part No 1134791