JVC AV-56WP30 Instructions - Page 16

Connections Connecting to a Digital TV Receiver w/HDCP By inputting a high bandwidth Digital Content Protection High Definition picture source to the Digital-In terminal of this television, high-definition pictures can be displayed on the screen in their digital form. (This terminal is for use in the future when high bandwidth Digital Content Protection DTV decoders and DVD players and D-VHS are put on the market.) AUDIO DIGITAL IN After the connections have been made, tighten the screw to secure the cables. R L AUDIO OUT L R DIGITAL OUT DTV decoder 1) Connect the DTV digital RGB output terminal to the digital input terminal of the television, and then tighten the 2 screws. 2) Connect the DTV decoder left audio output to the DIGITAL-IN left audio input. 3) Connect the DTV decoder right audio output to the DIGITAL-IN right audio input. • The Digital-In terminal can only be used with 1080i, 720p and 480p picture signals. Set the DTV decode Digital-Out terminal output setting to 1080i, 720p or 480p. For detailed information, refer to the DTV decoder instruction manual. If you can not display the picture because your DTV decoder does not have a Digital-Out terminal output setting, use the component Video Input (or the S-Video Input or Video Input). (Refer to page 15) In this case the picture will be displayed as an analog signal. • The Digital-In terminal is not compatible with the picture signal of a personal computer. • Use a DVI-D Single Link 19-pin cable (commercially available) in order to digitally connect the television with a DTV decoder. If 480p signals (640x480 or 720x480) are displayed on the screen, the horizontal balance may be slightly shifted. In cases such as this, the horizontal balance can be adjusted by accessing "DIGITAL-IN" in the INITIAL SETUP Menu. (Refer to page 41.) 16