JVC AV-56WP30 Instructions - Page 57

Button Functions NUMBER BUTTONS - 10 KEY PAD Use the number buttons on the remote control to move directly to a specific channel. For example, to move to channel 7: 0 (Zero) 7 (Seven) 100+ BUTTON Use the 100+ button to directly access channels above Channel 99. For example, to move to channel 124: 100+ 2 (Two) 4 (Four) RETURN+ The RETURN+ button has two functions: Return - Returns to the channel viewed just before the channel currently onscreen. Return+ - Lets you program a specific channel to return to while scanning through the channels. To program: RETURN+ and hold for three seconds. RETURN CHANNEL PROGRAMMED ! You can now scan through the channels using the CH+/- buttons. RETURN+ You will return to your programmed channel. • To cancel your RETURN+ channel, press and hold the RETURN+ button for three seconds. The message "RETURN CHANNEL CANCELLED!" will appear. • RETURN+ works only with CHANNEL+/-. Pressing any number key will cancel RETURN+. V-CHIP By pressing the remote control V-CHIP button, the V-chip rating information for the program which is being received is displayed on the screen. If the V-chip rating information is not being sent, "UNRATED" is displayed on the screen. If the zero ("0") button is pressed while the V-chip rating is displayed on the screen, all categories with the same or a higher V-chip rating will be blocked. For example, if you block movies rated NC-17, movies rated X will also be blocked. • V-chip blocks can be manually set one at a time by using the V-chip option in the INITIAL SETUP menu. For detailed information about V-chip ratings and V-chip manual settings, refer to pages 33 to 38. 57