JVC BR-DV6000U User Manual - Page 46

RECORDING - Recording with serial remote terminals - Recording can be turned ON/OFF with a serial remote controller or foot switch connected to the SERIAL REMOTE IN terminal located at the rear panel of BR-DV6000. Mini MENU DISP RESET SEARCH- SET SEARCH+ MIC HOLD BLANK CUE UP PHONES REC LEVEL CH-1/3 CH-2/4 PROFESSIONAL BR-DV6000 OPERATE A.DUB REC PLAY PAUSE EJECT REW STOP FF AUDIO INPUT COUNTER MONITOR OUTPUT SELECT CTL L CH-1/2 DV TC MIX MIX LINE UB R CH-3/4 Y/C (CPN) REMOTE LOCAL REMOTE/LOCAL switch VIDEO LINE Y/C COMPONENT IN R-Y B-Y Y OUT REMOTE2 IN OUT AUDIO CH 1/3 CH 2/4 IN MONITOR OUT SIGNAL GND DC12V SYNC IN IN DV IN/OUT OUT TIME CODE IN OUT OFF REC PLAY SERIAL REMOTE TIMER OUT MONITOR OUT REMOTE1 SERIAL IN SERIAL OUT REMOTE (1/2) Menu screen ---R E MO T E [ 1 / 2 ] --- REMOT E S E L 9 P REMOT E S E L S ER REMOT E S E L DV REMOT E S E L J VC REMOT E S E L NE T LOCA L FUNCT I ON PREROL L NEXT PAGE PAGE BACK ON ON ON ON ON STP+EJT 7SEC Memo ● Besides recording, the serial remote controller can perform other functions. ● If the REMOTE SEL SER is set to ON, unit buttons that can be operated can be selected from LOCAL FUNCTION in the REMOTE (1/2) Menu screen. REMOTE (2/2) Menu screen ---R E M O T E [ 2 / 2 ] --- REM F F / REW MODE REM STOP SEL . PB START DELAY SYNCHRON I ZAT I ON CONTROL LER SEL FOOT SW PAGE BACK F F / REW EE OF ON TYPE1 OFF Serial IN terminal Foot switch Signal H L 400ms Min 46 :Connection: • Serial remote controller: RM-G30 • Foot switch The serial remote controller (RM-G30, sold separately) can be con- nected to the SERIAL REMOTE IN terminal located on the rear panel of BR-DV6000. The input signals of the SERIAL REMOTE IN terminal can be through- output from the SERIAL REMOTE OUT terminal. (Only with OPER- ATE ON) :Setting: Ⅵ To use the SERIAL IN terminal, set REMOTE SEL SER in the REMOTE (1/2) Menu screen to ON or LOC+REM. Then, set the REMOTE/LOCAL switch on the front panel accordingly. ● REMOTE SEL SER ON : When the REMOTE/LOCAL switch is set to REMOTE, operations can be performed via the SERIAL REMOTE IN terminal. LOC+REM: With the REMOTE/LOCAL switch is set either way, operations can be performed via the SERIAL REMOTE IN terminal.With this setting, the buttons and switches of the unit can be used too. Ⅵ Set FOOT SW in the REMOTE (2/2) Menu screen according to how the serial remote terminal is used. OFF : Set to OFF when the serial remote controller is used. The footswitch cannot be used. L EDGE : Recording and recording pause is switched at the LOW edge of the footswitch signal. H EDGE : Recording and recording pause is switched at the HIGH edge of the footswitch signal. L LEVEL : Recording is performed at the LOW edge and paused at the HIGH edge of the footswitch signal. :Operation: Before using the foot switch, set BR-DV6000 to the RECORDING or RECORDING PAUSE mode using the relevant buttons of the unit. (Only with L EDGE and H EDGE) Memo ● The foot switch can only be used to switch between RECORDING ON and OFF. ● The foot switch can be operated regardless of the setting of the REMOTE/LOCAL switch.