JVC DWF10 Instruction Manual - Page 8
English, Turning On the Power-POWER, Operating the Unit Automatically According to the Incoming, - sp subwoofer
UPC - 046838011801
View all JVC DWF10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
English Connections ENGLISH Before connecting this unit to the amplifier (or receiver), observe the following carefully. • Turn off the amplifier. • Make all connections before plugging in this unit. • DO NOT connect this unit to the REC OUT jacks of your amplifier. It may damage your subwoofer. Amplifier or Receiver Monaural audio cord (Supplied) To LINE OUT To SUBWOOFER OUT or MONO To an AC outlet SP-PWE5 Stereo audio cord (not Supplied) In the case that the receiver dose not have the SUBWOOFER OUT or MONO terminal. Operations SP-PWE5 (Front) SP-PWE5 (Rear) SP-DWF10 (Front) Rear view SP-DWF10 To an AC outlet SP-DWF10 (Rear) Power lamp Turning On the Power-POWER To turn on the power. Press the POWER switch to the [ ❙ or • The power lamp lights in green. ] ON position. SP-PWE5 SP-DWF10 POWER ON OFF To cut of the power. Press the POWER switch to the [ ‡ or • The power lamp goes out. • This will disconnect the mains lead. ] OFF position. SP-PWE5 SP-DWF10 POWER ON OFF Power lamp Operating the Unit Automatically According to the Incoming Signals-AUTO POWER ON/STANDBY To activate AUTO POWER ON/STANDBY. Press the AUTO POWER ON/STANDBY switch to the [ position. • If no sound comes in for 5-10 minutes, the unit enters standby mode. The power lamp lights in red. • If the unit detects incoming signals, the unit starts operating. The power lamp lights in green. ] ON To cancel AUTO POWER ON/STANDBY. Press out the AUTO POWER ON/STANDBY switch to set it to the [ ] CANCEL position. AUTO POWER ON / STANDBY ON CANCEL When the volume level of the amplifier is so low or the incoming signals are so weak that this unit cannot detect sounds, Auto Power On/Standby may not work correctly. - 8 -