JVC FS-G6 Instruction Manual - Page 15

Basic Settings English REMOTE CONTROL RM-SFSG6J PANEL OPEN/CLOSE DIMMER POWER ACTIVE BASS EX. CLOCK/TIMER SLEEP BASS TREBLE FM MODE PLAY MODE REPEAT AUTO PRESET TITTLE/EDIT ENTER DISPLAY /CHARA. CANCEL UP < SET > DOWN MD AUX DIMMER CLOCK/TIMER MULTI JOG SET CANCEL < / > POWER STANDBY/ON CO M PA CT COMPONENT S Y S T E M F S -G 6 OPEN/CLOSE FM/AM MULTI JOG MOS - FET VOLUME AUX Display window Before operating the system any further, set the clock built in this system first, then some other basic settings. Setting the Clock You can set the clock using the remote control whether the system is turned on or turned off (i.e. standby mode). 1 Press CLOCK/TIMER button on the remote control. The hour digit in the display window starts blinking. Setting the Display Illumination (Dimmer) You can adjust the brightness of around the display window. Each time you press DIMMER button, the display window dims and brightens alternately. • While the system is turned off: Press DIMMER button, "DISPLAY OFF" appears in the display window for a while and the system clock disappears. 2 Press < / > button on the remote control to adjust the hour, then press SET button on the remote control (rotating MULTI JOG dial also available). Press the button again, "DISPLAY ON" appears in the display window for a while and only the system clock become dimmed. • To correct the hour after pressing SET button, press CANCEL button. The hour digit starts blinking again. 3 Press < / > button on the remote control to adjust the minute, then press SET button on the remote control (rotating MULTI JOG dial also available). • While the system is turned on: Press DIMMER button, both operating information and indicators in the display window dims. The light around MULTI JOG dial also becomes darker than usual. Press the button again, all the illumination around the display window recovers as usual. If there is a power failure The clock loses the setting and is reset to "AM 12:00." To adjust the clock again You need to press CLOCK/TIMER button five times until the clock setting mode is selected. Dimmer setting in the standby mode Once the system is turned on, the dimmer setting in the standby mode does affect neither normal operations nor display indications. 10