JVC KD-X320BTS Instruction Manual - Page 23

AUDIO SETTINGS AUDIO BASS BOOST LOUD SUB.W LEVEL*4 SUB.W *6 SUB.W LPF*4 SUB.W PHASE*4 FADER BALANCE *7 VOL ADJUST AMP GAIN +01 / +02: Selects your preferred bass boost level. ; OFF: Cancels. 01 / 02: Boosts low or high frequencies to produce a well-balanced sound at low volume. ; OFF: Cancels. SPK-OUT*5 00 to +06 (+03): Adjusts the output level of the subwoofer connected via speaker lead. ( 29) PRE-OUT*6 -08 to +08 (00): Adjusts the output level of the subwoofer connected to the lineout terminals (REAR/ SW) through an external amplifier. ( 29) ON / OFF: Turns on or off the subwoofer output. THROUGH: All signals are sent to the subwoofer. ; LOW 55HZ / MID 85HZ / HIGH 120HZ: Audio signals with frequencies lower than 55 Hz/ 85 Hz/ 120 Hz are sent to the subwoofer. REVERSE (180°)/ NORMAL (0°): Selects the phase of the subwoofer output to be in line with the speaker output for optimum performance. (Selectable only if a setting other than [THROUGH] is selected for [SUB.W LPF].) R06 - F06 (00): Adjusts the front and rear speaker output balance. L06 - R06 (00): Adjusts the left and right speaker output balance. -05 - +05 (00): Presets the volume adjustment level of each source (compared to the FM volume level). Before adjustment, select the source you want to adjust. ("VOL ADJ FIX" appears if FM is selected.) LOW POWER: Limits the maximum volume level to 30. (Select if the maximum power of each speaker is less than 50 W to prevent damaging the speakers.) ; HIGH POWER: The maximum volume level is 50. D.T.EXP (Digital Track Expander) ON: Creates realistic sound by compensating the high-frequency components and restoring the rise-time of the waveform that are lost in audio data compression. ; OFF: Cancels. SPK/PRE OUT Selects the appropriate setting to get the desired output. (See the following table.) *4 Displayed only when [SUB.W] is set to [ON]. *5 Displayed only when [SPK/PRE OUT] is set to [SUB.W/SUB.W]. *6 Displayed only when [SPK/PRE OUT] is set to [REAR/SUB.W] or [SUB.W/SUB.W]. *7 This adjustment will not affect the subwoofer output. SPK/PRE OUT Connection via lineout terminals ( 29) Setting REAR/REAR REAR/SUB.W SUB.W/SUB.W FRONT Front speakers output Front speakers output Front speakers output Lineout terminal REAR/SW Rear speakers output Subwoofer output Subwoofer output Connection via speaker leads ( 29) Setting L (left) Rear speaker lead R (right) REAR/REAR Rear speakers output Rear speakers output REAR/SUB.W Rear speakers output Rear speakers output SUB.W/SUB.W Subwoofer output (Mute) If [SUB.W/SUB.W] is selected: - [HIGH 120HZ] is selected in [SUB.W LPF] and [THROUGH] is not available. - [R01] is selected in [FADER] and selectable range is [R06] to [00] ENGLISH 21